- If you want to use your Santa to hold a small gift or candy,
cut a circle of paper about 3" in diameter and glue to the bottom of the paper roll before proceeding to the next step.
Cut small wedge-shaped pieces out of the edges of the paper piece and glue the tabs up around the edges of the paper roll. (The raw edges will be covered in the next step.)
If you want to use your Santa as an ornament, you can skip this step.
- Cut a piece of white construction paper 6" x
Roll it around the tissue roll to cover it and glue in place.
- While the glue is drying, cut out a pink face, white mustache, white hat band and red hat from construction paper using the patterns provided.
- Glue the face about � " down from the top of the paper roll.
- Glue the mustaches to the bottom � of the face. If using a pom-pom for a nose, glue it to the center of the mustache. If you are not making a pom-pom nose, color a red circle in the center of the mustache piece for the nose.
- Make 2 small dots above mustache for eyes.
- Make Santa's hat by rolling red construction paper piece into a cone. Glue edges together. Make sure that the open edge of the hat is slightly larger than the top of the toilet roll.
- Glue the white hatband around the edge of Santa's hat
- If you want to use your Santa as an ornament, poke 2 holes about � " down from the top edge of the toilet roll on either side of the face piece. Cut a piece of string or ribbon 12" long and run through the holes. Tie the ends together in an over-hand knot. Glue the hat to the top of the roll.
Click here to go to Patterns.
|